4 plant modular hydroponic tower section

Description: This tower is a combination of aeroponics and a drip system. This is used to build your own custom tower for a much lower cost than what you can buy a typical hydroponic tower for or you can purchase this part to add-on to your existing tower within this same system. This is a single 4 way plant module for a custom hydroponic tower, you can stack as many together as your water pump can handle (typically a pump can pump water between 7-10 ft). It is made out of PETG, it is heat and weather resistant and can be used indoor or outdoor. It includes spacers between each plant unit than can be used to either hold a grow light, be used as a tie down, or can be used to put plant label plaques. The following items are not included but are used in combination with this tower; 5 gallon bucket, 5 gallon bucket lid, bucket tower connector, 5 or 4 way plant modules, top or bottom light hanger, lock in net pots, blank lock in net caps, top tower cap, water pump that can reach 5-10ft, PVC pipe or 6/8 inner diameter flexible tubing to connect the water pump to the top of the tower. A timer can be used wit the water pump for 15minutes on and 30 minute off cycles or you may leave the water pump on 100% of the time.

Price: 20 USD

Location: Denver, Colorado

End Time: 2025-02-14T20:14:18.000Z

Shipping Cost: 2 USD